AMX instruction manual PCS2 Programming

Page 16

Operation and Programming

!A one- or two-second delay.

!Verification of status changes.

During transitions between states, the PCS may take 1 to 2 seconds to stabilize and its output indication may be incorrect. Failure to observe this delay may cause the Axcess, Axcent2, or Axcent3 system to repeatedly cycle power on the unit being sensed.

PCS2 Programming

When connecting a unit/system to the PCS2, be aware that a 1 or 2 second PCS2 circuitry stabilization consideration must be accounted for.

During transitions between states, the PCS2 may take 1 to 2 seconds to stabilize and its initial output indication may be incorrect. Failure to account for this possible de-lay may cause the Axcess, Axcent2, or Axcent3 system to repeatedly cycle power on the unit being sensed.

 

12

PCS and PCS2 Power Current Sensors

 

 

 

Image 16
Contents PCS and PCS2 AMX Limited Warranty and Disclaimer Table of Contents Table of Contents Specifications Product InformationProduct Information Installation PCS and PCS2 InstallationWiring Guidelines Rack mounting the PCS2Preparing captive wires PCS to AXC-INP8PCS to Axcent, Axcent2, or Axcent3 PCS2 to AXC-INP8PCS2 to Axcent, Axcent2, or Axcent3 PCS to Television Controllers PCS2 to Television ControllersCalibration PCS CalibrationStandby and On level relationship PCS2 Calibration Calibration Operation and Programming PCS OperationPCS2 Operation ProgrammingPCS2 Programming Operation and Programming PCS and PCS2 Power Current Sensors AMX reserves