Setup Instructions Connecting the Batteries

Setup Instructions

Connecting the Batteries

The UPS1500EPM ships with the eight batteries installed inside the unit. Before use, you will need to connect the main power connector inside the unit:

1.Remove the Release tabs on the front panel (see FIG. 1) to expose the screws that secure the Battery Compartment Cover.

2.Remove the screws beneath the Release tabs (FIG. 3).

FIG. 3 Remove the screws that secure the Battery Compartment Cover

3.Remove the Battery Compartment Cover to access the Battery Com- partment.

4.Connect the 4-pin connector from the battery cable harness to the matching connector inside the unit (FIG. 4).

4-pin connector power connector inside the enclosure

4-pin connector from the battery wiring harness

FIG. 4 Connect the battery cable harness to the matching connector inside the unit

Connecting the EPM To The UPS

FIG. 5 illustrates connecting the DC Cable on the EPM(s) to the UPS:

FIG. 5 Connect DC Cable

EPM - Storage Instructions

For extended storage through moderate climate +5 - +86 °F

(-15 - +30 °C), the batteries should be charged for 12 hours every 6 months by plugging the UPS power cord into the wall receptacle.

Repeat this every 3 months under high temperature +86 to +113 °F (+30 to +45 °C) environment.

For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).	93-0678-32	REV: A

2/07

AMX reserves the right to alter specifications without notice at any time.

3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com