Connecting your equipment
DVD(STB) COAX jack (page 10)
Coaxial digital audio jack for the DVD input (although it is possible to reassign it to the STB input).
7 SCART AV connectors
The four
VIDEO IN/OUT AV connector (page 12)
AV connector for the VIDEO input. When the receiver is set to any other input, that signal is output from the VIDEO IN/OUT AV connector.
DVR/TV IN/OUT AV connector (page 10)
AV connector for the DVR/TV input. When the receiver is set to any other input, that signal is output from the DVR/TV IN/OUT AV connector.
DVD IN AV connector (page 10)
AV connector for the DVD input.
STB IN AV connector (page 11)
AV connector for the STB input.
The table below shows the input and output video formats available for each AV connector.
Connector | Input | Output |
DVD | Composite, | – |
| RGB |
|
|
|
|
STB | Composite, | – |
| RGB |
|
|
|
|
VIDEO | Composite, | Composite |
| RGB |
|
|
|
|
DVR/TV | Composite | Composite, |
|
| RGB |
|
|
|
from your satellite receiver to your VCR (both connected to this receiver) without the receiver being switched on. You could also use the AV Direct mode to watch a video, using your TV’s speakers for the audio, without switching on the receiver.
You can switch into AV Direct mode (from either standby or on) using the AV DIRECT button on the remote control. However, it’s also possible to set the receiver to switch the AV Direct function on automatically when an incoming signal is detected. See also AV Direct setting on page 33.
The diagram below shows how the AV DIRECT and the STANDBY/ON buttons switch the receiver between
standby, AV Direct mode, and on.
| Standby |
| Standby |
|
|
| RECEIVER |
| AVDIRECT |
|
|
AV Direct | On | AV Direct | On |
Installing the receiver
•When installing this unit, make sure to put it on a secure and level plane that is stable.
•Don’t place it on the following places:
–on a color TV (the screen may distort)
–near a cassette deck (or close to a device that gives off a magnetic field). This may interfere with the sound.
–in direct sunlight
–in damp or wet areas
–in extremely hot or cold areas
–in places where there is a vibration or other movement
–in places that are very dusty
–in places that have hot fumes or oils (such as a kitchen)
03
English
•All AV connectors also have audio in. The VIDEO and DVR/TV connectors also have audio out.
•The VIDEO and DVR/TV connectors are compatible with
When making cable connections
Be careful not to arrange cables in a manner that bends the cables over the top of this unit. If the cables are laid on top of the unit, the magnetic field produced by the transformers in this unit may cause a humming noise to come from the speakers.
The AV Direct mode
The AV Direct mode allows the receiver to pass audio/ video signals arriving at one of the AV connector inputs to the AV connector outputs without the sound being output through the speakers connected to the receiver. This allows you to operate your other components as if they were connected directly to each other without the receiver being on. One use for this is if you want to record
9
En