Quick start guide
Chapter 1
Quick start guide
Introduction
This ‘Quick start guide’ shows you how to connect your speakers, TV and DVD player to this receiver, and also takes you through switching on and playing a DVD disc.
1Connect your speakers to the receiver, as shown in the diagram below.
Prepare the speaker cable by stripping about 1 cm of the plastic shielding from each speaker wire.
01
English
Easy Setup
This section shows you how to connect your speakers, subwoofer, DVD player and TV to this receiver so you can start enjoying home cinema sound right away.
Before you start, make sure everything you’re connecting is switched off and unplugged.
Connect the front speakers to the FRONT L/R terminals; the center speaker to the CENTER terminal; and the surround speakers to the SURROUND L/R terminals.
Press on a tab to open a terminal; insert the exposed wire, then release the tab to secure.
Connecting speakers
This receiver has speaker terminals for front left and right speakers (L and R in the diagram), a center speaker (C) and two surround speakers (RS and LS). The minimum speaker configuration is just the front left/ right speakers, but we recommend connecting all five if possible. Note that surround speakers should always be connected as a pair; do not connect just one surround speaker. All the speakers you use should have a nominal impedance between
For correct sound it’s important that the positive and negative terminals of the receiver and each speaker are matched. To help you do this, attach the supplied colored
2Connect a powered subwoofer to the SUBWOOFER OUT jack, as shown in the diagram below.
Use a standard audio cable with RCA/phono plugs.
|
| SPEAKERS |
|
| |
| FRONT | CENTER | SURROUND | ||
R | L | R | L | ||
|
ANTENNA
AM LOOP
|
| FMUNBAL75Ω |
|
|
| DIGITAL IN |
|
SUB | STB | DVR/TV | DVD |
WOOFER | (DVD) |
| (STB) |
OUT | OPT1 | OPT2 | COAX |
AC IN
IN |
|
|
| OUT |
|
CONTROL | VIDEO IN/OUT | DVR/TV IN/OUT |
| ||
|
| AV CONNECTOR |
| DVD IN | STB IN |
LINE LEVEL
R | L | C | RS | LS |
SW
5
En