![](/images/new-backgrounds/1191490/19149025x1.webp)
TANDBERG Videoconferencing System | Installation |
|
|
3. ISDN cables
•Connect the ISDN cables to the ISDN sockets
NOTE
SOME SOFTWARE VERSIONS DO NOT SUPPORT THREE ISDN LINES
North America: The TANDBERG 550 does not have a
NOTE WRITE DOWN THE NUMBERS ASSOCIATED WITH EACH OF THE ISDN LINES. YOU WILL NEED THEM LATER TO CONFIGURE THE SYSTEM.
NOTE CONNECTING TO THE SWITCHED 56 NETWORK: WHEN CONNECTING TO THE SWITCHED 56 NETWORK YOU MAY USE ONE OF THE BRI INTERFACES ON THE TANDBERG 550. PLEASE REFER TO APPENDIX 2 FOR FURTHER INFORMATION.
4. Power cable
•Connect the power supply to the ‘DC in’ input on the system.
•Connect the power cable to the power supply.
•Connect the power cable to an electrical distribution socket.
5a. LAN cable
• To use the system on LAN, connect a LAN cable from the ‘Ethernet’ connector on the system to your LAN.
5b. Wireless LAN - Insert PC Card
•Remove the “dummy” card by pressing the ‘Eject’ button next to the slot.
•Insert the Wireless LAN PC Card.
NOTE
MAKE SURE YOU INSERT THE CARD IN THE RIGHT DIRECTION (WITH THE PRODUCT LOGO POINTING UPWARDS). PUSH THE CARD INTO THE SLOT UNTIL THE ‘EJECT’ BUTTON POPS UP.
See ‘Wireless LAN Settings’ for configuration.
13