Advantek Networks ANS-24RV FCC Warning, Copyright1999 All Rights Reserved, CE Mark Warning

Page 2

FCC Warning

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy, and if it is not installed and used in accordance with the instruction manual, it may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense.

*Shielded interface cables must be used in order to comply with emission limits

Changes or modifications to the equipment, which are not approved by the party responsible for compliance, could affect the user's authority to operate the equipment.

Copyright_1999 All Rights Reserved.

Company has an on-going policy of upgrading its products and it may be possible that information in this document is not up-to-date.

Please check with your local distributors for the latest information.

No part of this document can be copied or reproduced in any form without written consent from the company.

CE Mark Warning:

This is a Class A product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

Trademarks:

All trade names and trademarks are the properties of their respective companies.

2

Image 2
Contents Port Fast Ethernet Switch With Vlan and Trunking CE Mark Warning FCC WarningCopyright1999 All Rights Reserved TrademarksContents Class of Service Configuration General Description Product FeaturesPackage contents Connecting computers to the switch Front panel LED indicatorsPower Connecting Rear panelTo prolong the operational life of your units Installing the Fast Ethernet Switch Configure system networkLogin the Web SmartSwitch Home overview Administrator Authentication ConfigurationSystem IP Configuration System StatusLoad Default Setting Firmware update Make Sure the Firewall SettingPage Port Configuration Port ManagementPort Mirroring Bandwidth ControlBroadcast Storm Control Multi to 1 Setting Vlan SettingGroup Vlan Setting Trunk Setting Trunk ConfigurationClass of Service Configuration QoS SettingPriority Mode MAC Address Configuration MAC AddressConfiguration Configuration Backup/RecoveryConnecting to the Switch Console Port Setup HyperTerminalPage Page Configure Switching Hub via COM1 Port Switch Main Menu Load Default Setting