|
| General Safety Information | |
|
| • Do not load the output terminals above the specified current limits. | |
WA RN I N G | |||
| • Do not use the device if it appears damaged or defective. | ||
|
| ||
|
| • Observe all markings on the device before connecting any wiring to | |
|
| the device. | |
|
| • Do no operate the device in the presence of flammable gases or | |
|
| fumes. | |
|
| • Do no install substitute parts or perform any unauthorized | |
|
| modification to the device. | |
|
|
| |
|
| • Applying excessive voltage or overloading the device will cause | |
C A U T I O N |
| ||
| irreversible damage to the circuitry. | ||
|
| ||
|
| • Use the device with the cables provided. | |
|
| • Repair or service that is not covered in this manual should only be | |
|
| performed by qualified personnels. | |
|
| • To avoid ESD damage to the RF switch driver board, users are highly | |
|
| recommended to comply with the following cautions: | |
|
| • User are required to discharge themselves to any large metal object | |
|
| (e.g. Shelf, desk, etc.) prior to operating the RF switch driver board. | |
|
| • Operate the RF switch driver board under an ESD protected workstation, | |
|
| with the minimum requirements of using wrist strap (connected to ground) | |
|
| and ESD pad. The wrist strap can be grounded by connecting to the power | |
|
| supply ground and/or circuit board ground. | |
|
| • Avoid human body contact or a charged material to the | |
|
| and circuitries. Always hold the board edges when carrying the RF switch driver | |
|
| board. | |
|
|
|
IV |