SMARTNET/SMARTZONE FEATURES
Direct Entry Method (Full Keypad Models Only)
1.With a SMARTNET/SmartZone channel selected, press and hold the Private Call option switch until a tone sounds (approximately 1 second). The last ID called is displayed, and the private call mode is indicated by “C” in the upper part of the display.
2.Using the 
key to erase the last digit entered or press the CLR key to cancel the call.
3.Press the PTT switch or the ENT key to initiate the call. If the entered ID is invalid, “INVALID” is momentarily displayed and the call is not initiated. If the entered ID is valid, the display indicates the alias of the ID if it matches an ID in your call list. Otherwise, the ID you entered continues to be displayed. Any of the following conditions may then occur:
•If the radio you are calling is on the air, telephone type “ringing” is heard for 20 seconds or until the called party answers.
•If the called party answers and the call is successful, the person’s voice is heard and the call is carried on the same as a group call. To end the call at any time, press the CLR key.
•If the called party does not answer within 20 seconds, “NO ANSWR” is displayed and a continuous tone sounds. End the call by pressing the CLR key.
•If the called radio is not in service, no ringing is heard, “NO ACK” is displayed, and a continuous tone sounds. End the call by pressing the CLR key.
•If neither your radio nor the radio being called is authorized to make
37