EFJohnson 7700 Series manual Receiving an Enhanced Private Conversation Call

Page 38

SMARTNET/SMARTZONE FEATURES

•If the called party answers but the radio system is busy, four low tones sound and “BUSY” and “WAIT” are alternately displayed. When the system is no longer busy, the called party automatically responds.

•If an out-of-range condition exists or the radio system is not in service, “LOST CALL” is displayed and a continuous tone sounds. End the call by pressing the CLR key.

Receiving an Enhanced Private Conversation Call

These calls are automatically received if a SMARTNET/SmartZone channel is selected. Proceed as follows:

1.When a call is received, a recurring unit call tone (three beeps) sounds for up to 20 seconds, and “CALL RCV” and the current channel alias are alternately displayed.

2.To answer the call, press the Private Call option switch and then the PTT switch and begin talking. The private call mode is indicated by “C” in the upper part of the display. The alias of the incoming call is displayed if the ID is in your call list. Otherwise, the unit ID is displayed. NOTE: If the Private Call option switch is not pressed before the PTT switch, a group call is transmitted on the selected group.

•To end the call when the conversation is complete or at any other time, press the CLR key.

•If unit-to-unit (private) calls are not permitted (Private Call switch not programmed), press the Call Response option switch, if available, to answer the call.

•If the call is not answered within 20 seconds, it is automatically terminated.

•If the radio system is busy, four low tones sound and “BUSY” and “WAIT” are alternately displayed. When the system is no longer busy,

38

Image 38

Contents Series Page Page Safety Information Other Important Operating Information Conventional Features FeaturesGeneral Features Smartnet II FeaturesTable of Contents Intrinsically Safe Classification Option Switch Functions Conventional ModeSMARTNET/SMARTZONE Mode Top Panel Controls Top Panel IndicatorsControls and Display Side Controls Front Panel Keys 3-Key Model Front Panel Keys 15-Key Model Display Introduction Turning Power On and Setting VolumeGeneral Operation Option Switches BacklightChannel and Zone Selection Low Battery IndicationKeypad Lock Channel SelectHome Zone Time-Out TimerZone Select Introduction Tone Enable/DisableScanning Standard Scanning Radio Wide ScanningRadio Wide Mode Scan List Scan Resume DelayStandard Mode Scan List Conventional and SMARTNET/SmartZone Operation Determining Which Channels are in Scan ListNuisance Channel Delete Conventional Operation SMARTNET/SmartZone OperationMonitoring Before Transmitting Conventional FeaturesDisplay Mode Selection Monitor Mode Busy Channel Lockout Call Guard SquelchPenalty Timer Repeater Talk-Around Conversation TimerPower Output Select Selecting a Scan List Conventional Mode ScanningGeneral Transmitting in Scan Mode Programming a Scan ListPriority Channel Sampling Changing The Priority ChannelStandard Conventional Calls Viewing Unit ID SMARTNET/SMARTZONE FeaturesDTMF/ANI Signaling Standard Group Calls Enhanced Private Conversation Calls Placing an Enhanced Private Conversation CallSMARTNET/SMARTZONE Features Receiving an Enhanced Private Conversation Call Private Conversation II Calls Placing a Private Conversation II CallSMARTNET/SMARTZONE Features Placing a Telephone Call Receiving a Private Conversation II CallTelephone Calls SMARTNET/SMARTZONE Features SMARTNET/SMARTZONE Features Call Alert Messaging Sending Status Conditions Emergency Alarm and Emergency Call Failsoft OperationSMARTNET/SmartZone Scanning Dynamic RegroupingDetermining Current Site and Searching For New Site Supervisory Tones MiscellaneousLocking/Unlocking a Site Miscellaneous Rechargeable Battery Pack Miscellaneous Operation At Extended Range Dealer ProgrammingSpeaking Into Microphone LicensingTransceiver Service Intrinsically Safe ClassificationClassification of Hazardous Areas Division Classification of Atmospheres Class/GroupIndex Typical Hazard Group ClassSmartnet 6 Index