D-Link DES-1218, DES1226 manual Power on, Power Failure

Page 18

DES-1218/DES-1226 10/100/1000 Mbps Ethernet Switch User’s Guide

Mounting the Switch in a standard 19” rack.

Figure 2-3 DES-1226 Switch in Rack

Power on

Plug one end of the AC power cord into the power connector of the switch and the other end into the local power source outlet.

After the Switch is powered on, the LED indicators will momentarily blink. This blinking of the LED indicators represents a reset of the system.

Power Failure

As a precaution, in the event of a power failure, unplug the switch. When power is resumed, plug the switch back in.

8

Image 18

Contents DES-1218 / DES1226 Wichtige Sicherheitshinweise Limited Warranty Limitation of Warranties CE Mark Warning Table of Contents Technical Specifications Cables and Connectors Cable Lengths Page About this Guide ConventionsOverview of this User’s Guide Page Introduction Fast Ethernet TechnologyGigabit Ethernet Technology Switching Technology DES-1218/DES-1226 10/100/1000 Mbps SwitchGeneral Description of Switch Performance features Ports Optional Gigabit Extension Modules1000BASE-SX MT-RJ Module DES-122GM Unpacking and Setup SetupUnpacking Desktop or Shelf Installation Rack InstallationPower on Power FailureIdentifying External Components Front PanelRear panel view of the Switch Rear PanelLED Indicators Side PanelsConnecting the Switch Switch to End NodeSwitch to Hub or Switch Connecting to Network Backbone or Server Gigabit Uplink ConnectionSwitch Management Local Console ManagementConsole port RS-232 DCE User Interface Management Console ScreenSoftware Features Priority Queues Example of Priority Queue AssignmentsVlan Group Port-based VLANsManagement Concepts Port Trunk GroupsIeee 802.1p Priority VLANsPort-based VLANs Vlan SegmentationVlan and Trunk Groups Technical Specifications StandardsEMI Cables and Connectors Standard RJ-45 port and connectorStraight cable for use with MDI-II to MDI-X connections Cable Lengths Page Offices Singapore D-LINK International Registration Card