D-Link DES-3224 manual

Page 56

10/100 Auto Negotiation Switch User’s Guide

Follow these steps to configure the SNMP Trap Manager Setting:

1.Enter the IP Address of the Trap Manager.

2.Enter the name of the SNMP Community String.

3.Select Status and toggle the space bar to select Valid or Invalid.

4.Select Save and press Enter.

Managing the DES-3224

46

Page 55 Page 57
Image 56
Page 55 Page 57
Contents DES-3224 10/100 Auto Negotiation Switch User’s Guide Link Limited Warranty Hardware North, Central, and South America FCC Warning Wichtige Sicherheitshinweise Page Table of Contents Page Page Page Organization About This GuideAudience Front Panel FeaturesIntroduction Side Panels MDI-Uplink port MDI-X portsRear Panel Management MethodsLocal Console Management Telnet ManagementUpdating Firmware Unpacking the DES-3224 Installing the DES-3224Installation Options Rack Installation Power OnDesktop/ Shelf Installation Connecting the DES-3224 to the Network Cable SpecificationsCable Diagram Cable Requirements Ports MDI-II PortMDI-X Port RS-232 PortConnecting the DES-3224 to the DES-5024 and Hubs DES-3224 to DES-3224 ConnectionPower LED LEDsFull/ Half LED DES-3224 LED PanelSpeed/ Link/ Activity LED Utilization LEDs Managing the DES-3224 Local Console ManagementTelnet ∙ Parity None ∙ Stop bits ∙ Flow Control None∙ Default User Name D-Link ∙ Default Password D-Link LogHelp Message Help MessageSpacebar System Configuration Switch Port 1-8, 9-16, 17-24 ConfigurationSpanning Tree Configuration Console ProgramSystem Configuration Menu Snmp Management ConfigurationVlan Port Management Trunking Port ManagementSystem Reset Factory Reset to Default Config ValuesSoftware Update System InformationBoot Prom Firmware Version System Information MenuHardware Revision Software VersionLAN Default Gateway System DescriptionSystem Name System LocationSystem Reset System ResetFactory Reset Factory ResetFactory Reset Confirmation Disadvantages of Store and Forward System Rate ControlAdvantages of Store and Forward Advantages of Cut-Through Disadvantages of Cut-ThroughSoftware Update Menu Software UpdateSoftware Update Transfer Message Displayed as Eeprom is Being Written Create New User User Account ManagementUser Account Change Menu Password Confirm PasswordAccess Level User NameDelete Users StatusDelete New Password Change PasswordOld Password State Switch Port ConfigurationSwitch Port Configuration Menu Priority PhysicalPort State STA Operation Levels Spanning Tree ConfigurationSpanning Tree Configuration Menu Forward Delay Time Spanning Tree AlgorithmBridge Priority Root CostRoot Bridge Root PortSnmp Management Configuration Snmp Management Configuration MenuSnmp Community String Snmp Manager SettingAccess Right Snmp Trap Manager Setting Authentication FailureCold Start Link Change EventPage Vlan Port Management Vlan Port Management MenuVlan Port Management menu Create/ View Vlan New Vlan NamePort # TrunkGroupDelete Vlan Menu Vlan NameModify Vlan Menu Virtual LAN NameVlan Modify menu Trunking Port Management Menu Trunking Port Management menuName Create New Trunking PortNew Trunking Group Name Delete Trunking Port Trunking PortModify Trunking Port Trunking Port NameTrunking Port Modify menu Troubleshooting Problem SolutionPower LED is Off System Error LED Indicators Port Specifications DES-3224 Technical SpecificationsSwitch Specifications General EMI Access Level IndexUser Name 34, 35
Top Page Image Contents