D-Link DE-824TP, DE-81 6TP, DE81 2TP+ manual Connecting Power, AUI port AU1 c a b l e Transceiver

Page 11
AUI port

To connect the Ethernet Hub to a thick coaxial cable (lOBase cable), it is necessary to have a lOBase Ethernet transceiver (tap) on the cable at the Ethernet Hub’s position. Then run an AUI cable between the transceiver’s AUI connector and the AUI connector on the rear panel of the Ethernet Hub.

AUI port

-AU1 c a b l e

Transceiver x

Connecting Power

For compatibility with electric service in most areas of the world, the Ethernet Hub’s power supply automatically adjusts to line power in the range 100 - 240 VAC and 50 - 60 Hz.

Per ordering option, either a Type 1 (US) or Type 2 (European) power cord is supplied with your Ethernet Hub. See Spefications, below, for power cord details.

Ascertain that the power switch on the rear panel of the Ethernet Hub is in the off position. Plug the female end of the power cord firmly into the

9

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Page About of ContentsInstalling ConnectingAbout this Guide Rack Mounting Installing Network Cables w UTP ’cable Hub-to-hub connection between Model DE812TP+ Ethernet Hubs requires a 1OBaseT crossover cable. In making a hub-to-hubEthernet Internal Crossover Features+ Model DE-816TP + Model DE-824TP Ethernet Hub Rules for Using the Uplink Featuretwo connectors would cancel one another, and the hub-to-hub connection would fail T o next node Thin coax Segment vAUI port AU1 c a b l e Transceiver Connecting PowerCollision LED LED IndicatorsJabber LED Specifications DE-812TP+ mm including mountingType 1 US or Type 2 Europe per 25OV, 1OA 25OV, 10A 1830mm 6ftTel . 46 - 08 - 70062 D-Link OfficeLe Florilege
Top Page Image Contents