Setting

Power management

For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not operated for a certain period.

Select one of the following options:

Ready

When the lamp has been fully cooled

 

down, the POWER indicator changes

 

to green blinking. In this condition,

 

the projection lamp will be turned on if

 

the input signal is reconnected or any

 

button on the top control or remote

Shut down

control is pressed.

When the lamp has been fully cooled

Off

down, the power will be turned off.

Power management function is off.

Timer

If the input signal is interrupted and

 

no button is pressed for more than

 

30 seconds, the timer display with

 

No signal appears. It starts the

 

countdown until the lamp is turned off.

 

Use the Point ▲▼ buttons to set the

 

Timer(1~30min).

Note:

Factory default is Ready: 5 min.

On start

When this function is set to On, the projector will be automatically turned on just by connecting the AC power cord to a wall outlet.

Note:

When Standby mode is set to Eco, On start cannot be selected. If you want to set On start to On, Standby mode must be set to Network.

Be sure to turn off the projector properly (see “Turning Off the Projector” on page 20). If the projector is turned off in the incorrect sequence, the On start function will not work properly.

Power management

Time left before Lamp is off.

50

Page 50
Image 50
Elmo CRP-26 owner manual Power management, Shut down, On start