Elmo CRP-26 Part Names and Functions Rear Terminal, ① CONTROL PORT, ③ COMPUTER IN 2 / MONITOR OUT

Part Names and Functions

Rear Terminal

① ② ③ ④ ⑤ ⑥

⑦ ⑧

①CONTROL PORT

When the projector is controlled by a computer, connect to this jack with serial control cable.

②COMPUTER IN 1 /S-VIDEO IN / COMPONENT IN

Connect analog RGB output signal from a computer, S-VIDEO output signal from video equipment, or RGB scart 21-pin video output or component video output to this terminal (pp.14-16).

③COMPUTER IN 2 / MONITOR OUT

–Connect analog RGB output signal from a computer to this terminal (p.14).

–This terminal can be used to output the incoming analog RGB and Component signal from

COMPUTER IN 1 /S-VIDEO IN /COMPONENT IN terminal to the other monitor (pp.14,16).

④AUDIO OUT (VARIABLE)

Connect an external audio amplifier to this jack (pp.14-16).

This terminal outputs sound from AUDIO IN terminal.

⑤VIDEO IN

Connect the composite video output signal to this jack (p.15).

⑥LAN Connection Terminal

Connect the LAN cable (refer to the owner’s manual of “Network Set-up and Operation”).

⑦AUDIO IN

Connect the audio output signal from computer or video equipment to this jack (pp.14-16).

⑧DC OUT 12V 1.1A

Connect the DC power cord (supplied) to this jack to supply DC 12V to a document camera.

Notes on using ELMO document cameras;

-The projector can supply 12V DC power to the document camera "L-1ex/TT-02RX" or "L-1n/TT-02s" with setting to Network mode of Standby mode menu. (p.51)

-Do not connect any other document cameras other than ELMO "L-1ex/TT-02RX" or "L-1n/TT-02s" with the supplied VGA/DC power combined cord. Otherwise damages may result.

-Use only the supplied VGA/DC power combined cord.

-When DC OUT 12V jack is plugged in, the cooling fans are running even if the projector is in standby mode.

9