D-Link DES-3208 manual Management

Page 18

10/100 Fast Ethernet Switch User’s Guide

♦Data forwarding rate 14,880 pps per port at 100% of wire-speed for 10Mbps speed.

♦Data forwarding rate 148,800 pps per port at 100% of wire-speed for 100Mbps speed.

♦Data filtering rate eliminates all error packets, runts, etc. at 14,880 pps per port at 100% of wire-speed for 10Mbps speed.

♦Data filtering rate eliminates all error packets, runts, etc. at 148,800 pps per port at 100% of wire-speed for 100Mbps speed.

♦8K active MAC address entry table per device with self learning and table aging.

♦8 MB packet buffer per device.

♦Supports broadcast storm rate filtering.

Management

♦RS-232 console port for out-of-band network management via a PC.

♦Spanning Tree Algorithm Protocol for creation of alternative backup paths and prevention of indefinite network loops.

♦D-View Network Management Program for standard SNMP-based management.

♦Fully configurable either in-band or out-of-band control via SNMP based software.

♦Flash memory for software up-grade. This can be done in-band via BOOTP/TFTP. D-View or out-of-band console can also initiate a download request.

♦Built-in SNMP management: MIB-I (RFC 1156), MIB-II (RFC 1213), Bridge MIB (RFC 1268) and D-Link proprietary MIB.

4

Introduction

Page 17 Page 19
Image 18
Page 17 Page 19
Contents DES-3208 10/100 Fast Ethernet Switch User’s Guide Wichtige Sicherheitshinweise Warranties Exclusive Limited Warranty Software Trademarks Page Page Table of Contents Switch Management Switch Monitoring Page About this Guide TermsOverview of this User’s Guide Appendix C, MII Port Specifications Introduction Fast Ethernet TechnologySwitching Technology Features Performance featuresPorts Management Unpacking Setup UnpackingSetup Desktop or Shelf InstallationRack Installation 100 Fast Ethernet Switch installed on a Desktop or ShelfPower on Power Failure Identifying External Components Front PanelRear Panel Rear panel view of the DES-320810/100 Fast Ethernet Switch User’s Guide LED Indicators DES-3208 Switch LED indicators10/100 Fast Ethernet Switch User’s Guide Connecting Switch PC to SwitchHub to Switch DES-3208 Switch connected to a 10BASE-T or 100Base-TX HubHub without Uplink MDI-II port 10Base-T Hub100Base-TX Hub Switch to Switch other devices Using straight cableUsing crossover cable Using straight cable Switch Management Local Console ManagamentConsole port RS-232 DCE IP Addresses and Snmp Community NamesTraps MIBs Packet Forwarding Aging Time Spanning Tree AlgorithmAutomatic topology re-configuration STA Operation LevelsUser-Changeable Parameters On the Port Level10/100 Fast Ethernet Switch User’s Guide Illustration of STA Before Applying the STA Rules User-selective STA parameters Using the Console Interface Connecting to the SwitchConsole Usage Conventions First Time Connecting To The Switch Super and General User Privileges Steps to create a Super User or General UserMain Menu for General User Super User and General User Privileges Login on the Switch Console by Registered Users Changing Your Password Choose Change PasswordAdding and Deleting Users Adding a New UserDeleting a User Setting up the Switch TCP/IP SettingsUsing the Console Interface Out-of-band management and console settings System Restart SettingSoftware Updates 11. Out-of-Band/Console Setting MenuSystem Configuration Menu 12. Software Update MenuSnmp Management Settings Snmp Trap Manager Configuration14. Snmp Trap Manager Configuration Menu Snmp Manager Configuration Snmp Security Community NamesPort Configuration 16. Port Configuration MenuSwitch Monitoring Displaying Port Statistics17. Statistics Counters Spanning Tree Algorithm Parameters Forwarding Table Custom Filtering Table 18. STA, Forwarding Table19. Custom Filtering Table Using the Console Interface Protocol Parameters Stap Port Parameters 21. Protocol ParametersResetting the Switch 22. Stap Port ParametersSystem Reset Factory Reset24. Factory Reset Technical Specifications GeneralPhysical and Environmental Performance Specification RJ-45 PINRJ-45 Connector pin assignment MII Connector Specifications Figure C-1. The Standard MII connectorMII Connector Pin Assignment Table C-1. The MII standard pin assignment BOOTP&TFTP, 48 Tftp only IndexIndex MDI-II Index Page Offices Registration Card

DES-3208 specifications

The D-Link DES-3208 is a robust and reliable Layer 2 Fast Ethernet unmanaged switch designed to enhance networking capabilities in both small and medium-sized businesses. With a compact and efficient design, the DES-3208 offers seamless connectivity for various devices, ensuring speedy data transfers and enhanced network performance.

One of the key features of the DES-3208 is its 8 Fast Ethernet (10/100 Mbps) ports, which allow for easy expansion of network infrastructure. The switch operates on a non-blocking architecture, which means it can handle multiple data streams simultaneously without compromising performance. This is particularly beneficial in environments where high traffic and data-intensive applications are commonplace.

The DES-3208 supports auto-MDI/MDIX functionality, which eliminates the need for crossover cables as the switch automatically detects the cable type connected. This feature simplifies network setup and allows for flexible configurations, enhancing usability for IT managers and system administrators.

Power-saving technologies are also a hallmark of the D-Link DES-3208. It features innovative Green Ethernet technology that reduces power consumption by detecting inactive ports and adjusting power usage accordingly. This not only contributes to environmental initiatives but also provides cost savings on energy bills over time.

Additionally, the switch supports a variety of network protocols to ensure compatibility with different network environments. These features include IEEE 802.3x flow control, which helps prevent packet loss during data transmissions, and IEEE 802.1p prioritization, ensuring critical traffic is processed in a timely manner.

The fanless design of the DES-3208 contributes to silent operation, making it an ideal choice for office environments where minimal noise is preferred. The compact form factor further allows for easy placement either on a desk or in a rack mount.

Overall, the D-Link DES-3208 is a versatile and efficient solution for businesses seeking an unmanaged switch that balances performance, energy efficiency, and ease of use. It adeptly meets the needs of growing networks while providing essential features that promote reliability and connectivity.
Top Page Image Contents