D-Link DES-1108 manual Mounting the Switch on the Wall, Mounting on a cement wall

Page 12

Section 2 - Installation

Mounting the Switch on the Wall

The DES-1108 can also be mounted on a wall. Two mounting slots are provided on the bottom of the switch for this purpose. Please make sure that the front panel is exposed in order to view the LEDs. Please refer to the illustration below:

Mounting on a cement wall

1.Mount the Nylon screw anchors into a cement wall.

2.Drive the T3 x 15L screws into the Nylon screw anchors.

3.Hook the mounting holes of the switch back on the screws.

Mounting on a wood wall

1.Drive the T3 x 15 L screws into the wood wall.

2.Hook the mounting holes of the switch back on the screws.

(1)3/4 inch minimum for wood wall

(2)3 inch minimum for cement wall.

D-Link DES-1108 User Manual

Image 12

Contents Page Table of Contents ProductPackageOverviewContents Switching Technology IntroductionFast Ethernet Technology Product Overview Features Product Overview Power Hardware OverviewFront Panel LEDs Link/ActivityDC Power Jack Rear Panel ConnectionsAuto MDI/MDI-X Ports Installation Connecting the SwitchPort Speed & Duplex Mode Mounting the Switch on the Wall Mounting on a cement wallMounting on a wood wall Troubleshooting Does the DES-1108 switch have an uplink port?What is Store-and-Forward switching? Networking Basics Check your IP addressStep Step Highlight Internet Protocol TCP/IP and click PropertiesTechnical Speciﬁcations DES-1108 SpeciﬁcationsMAC Address Learning Automatic update RJ-45 Connector pin assignmentRJ-45 Pin Speciﬁcations FCC Class B, CE Class BContacting Technical Support Phone SupportWarranty Limited WarrantyLimited Software Warranty Non-Applicability of WarrantyWhat Is Not Covered Disclaimer of Other WarrantiesLimitation of Liability Governing LawTrademarks Copyright StatementCE Mark Warning FCC StatementRegistration