D-Link DES-1108 manual Networking Basics, Check your IP address

Page 14

Appendix A - Networking Basics

Networking Basics

Check your IP address

After you install your new D-Link adapter, by default, the TCP/IP settings should be set to obtain an IP address from a DHCP server (i.e. wireless router) automatically. To verify your IP address, please follow the steps below.

Click on Start > Run. In the run box type cmd and click OK.

At the prompt, type ipconﬁg and press Enter.

This will display the IP address, subnet mask, and the default gateway of your adapter.

If the address is 0.0.0.0, check your adapter installation, security settings, and the settings on your router. Some ﬁrewall software programs may block a DHCP request on newly installed adapters.

D-Link DES-1108 User Manual

14

Image 14

Contents Page Table of Contents ProductPackageOverviewContents Fast Ethernet Technology Switching TechnologyIntroduction Product Overview Features Product Overview Front Panel LEDs PowerHardware Overview Link/ActivityAuto MDI/MDI-X Ports DC Power JackRear Panel Connections Installation Connecting the SwitchPort Speed & Duplex Mode Mounting on a wood wall Mounting the Switch on the WallMounting on a cement wall What is Store-and-Forward switching? TroubleshootingDoes the DES-1108 switch have an uplink port? Networking Basics Check your IP addressStep Step Highlight Internet Protocol TCP/IP and click PropertiesTechnical Speciﬁcations DES-1108 SpeciﬁcationsRJ-45 Pin Speciﬁcations MAC Address Learning Automatic updateRJ-45 Connector pin assignment FCC Class B, CE Class BContacting Technical Support Phone SupportWarranty Limited WarrantyLimited Software Warranty Non-Applicability of WarrantyWhat Is Not Covered Disclaimer of Other WarrantiesTrademarks Limitation of LiabilityGoverning Law Copyright StatementCE Mark Warning FCC StatementRegistration