D-Link DES-1005D manual Front Panel, Rear Panel, Identifying External Components

Page 17

IDENTIFYING EXTERNAL COMPONENTS

IDENTIFYING EXTERNAL COMPONENTS

This section identifies all the major external components of the DSS-5+. Both the front and rear panels are shown followed by a description of each panel feature. The indicator panel is described in detail in the next chapter.

Front Panel

The figure below shows the front and rear panels of the DSS- 5+ .

DSS-5+ 10/100M Dual Speed Ethernet Switch

LED Indicator Panel

Refer to the LED Indicator section for detailed information about each of the hub’s LED indicators.

Rear Panel

DSS-5+ 10/100M Dual Speed Ethernet Switch

DC Power Jack: Power is supplied through an external AC power adapter. Check the techni cal specification section for information about the AC power input voltage.

Since the switch does not include a power switch, plugging its power adapter into a power outlet will immediately power

7

Image 17

Contents RECYCLABLE VCCI Warning FCC CertificationsCE Mark Warning Product excluding power supplies and LIMITED WARRANTYWarranty Period fans, if purchased and delivered in the fiftyWhat You Must Do For Warranty Service What Is Not Covered IS” WITHOUT ANY WARRANTY OF ANY KIND INCLUDING, WITHOUT LIMITATION, ANY WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NON-INFRINGEMENT.IF ANY IMPLIED WARRANTY CANNOT BE DISCLAIMED IN ANY TERRITORY WHERE A PRODUCT IS SOLD, THE DURATION OF SUCH IMPLIED WARRANTY SHALL BE LIMITED TO NINETY 90 DAYS. EXCEPT AS EXPRESSLY COVERED UNDER THE LIMITED WARRANTY PROVIDED HEREIN, THE ENTIRE RISK AS TO THE QUALITY, SELECTION AND PERFORMANCE OF THE PRODUCT IS WITH THE PURCHASER OF THE PRODUCT ABOUT THIS GUIDE RJ-45PIN SPECIFICATION TECHNICAL SPECIFICATIONSSWITCH TO SWITCH OTHER DEVICES B. Using crossover cableTerms/Usage PurposeOverview of this User’s Guide ABOUT THIS GUIDEPage INTRODUCTION Fast Ethernet TechnologySwitching Technology Features allocated for each port, while controlling the data flow between the transmit and receive nodes to guarantee against all possible packet loss Unpacking SetupUNPACKING AND SETUP Page IDENTIFYING EXTERNAL COMPONENTS Front PanelRear Panel LED Indicators Page Page CONNECTING THE SWITCH PC to SwitchA. Using straight cable Hub to SwitchA. 10BASE-THub B. 100BASE-TXHubB. Using crossover cable Switch to Switch other devicesA. Using straight cable B. Using crossover cablePort Speed & Duplex Mode General TECHNICAL SPECIFICATIONSPhysical and Environmental Performance耟 The standard cable, RJ-45pin assignment RJ-45P IN SPECIFICATION耟 The standard RJ-45receptacle/connector

Related manuals

Manual 4 pages 23.69 Kb