D-Link 3.60.28 manual Related Documentation

DGS-3100 Series Firmware Release Notes

		configured as a LACP port. The
		LACP configuration does not take
		effect.
	3 The user can configure illegal IP
	address for several features, like “Trust	There is no problem if the user
	Host”, “Syslog”, “SNMP”, “SNTP”,
	“Radius” and “ARP”, without any	configures correct IP addresses
	warning message.
	4 When configuring “ipif”, the switch	It is displaying problem and no
	displays ''system'' but not ''System''
		effect on the functionality.
	5 Dynamic VLAN is not displayed in the	It was tested with IE7, it works
	VLAN page when the browser is in
		fine if lowering browser’s security
	security level high or medium-high.
		level
	6 If the user configures port security on
	specific ports via the CLI and
	configures trap on these ports and
	afterwards configures port security on
	other ports from the web without a	None
	trap, using the show port_security and
	show configuration running commands
	on CLI, the user can see that the trap
	appears also on the ports configured by
	via the web (without a trap)
	7 When user tries to show VLAN, STP and
	GVRP information via CLI, the ‘q’
	button does not interrupt the
	displaying when you type it. For	It does not affect the switch
	example: when you typed "show
	GVRP ?", the PORTLIST + LAG list was	functionality.
	printed, typed "q" to stop displaying
	but the rest of the LAGs were printed
	any way.
	8 QoS does not work properly when using
	queue 3 across the stack. It happens in	Do not use queue 3 under
	strict priority and also in WRR. When
	the user does not use queue 3	stacking topology
	everything works fine.
* D-Link tracking number is enclosed in ()

Related Documentation:

-DGS-3100 Series User Manual v3.6

-DGS-3100 Series CLI Manual v3.6

-DGS-3100 Series Hardware Installation Guide v3.5

14