DGS-3100 Series Firmware Release Notes

DGS-3100 Series Firmware Release Notes

v3.00.43

v2.50.43

1Modify Safeguard Engine command to support defining threshold

• config safeguard_engine {state [enable disable] {rising <value 20-100> falling <value 20-100>}}

2Modify the command “show_safeguard” to “show

safeguard_engine”

3Remove “enable safeguard” and “disable safeguard” commands

4Modify Traffic Segmentation command to support configuring multiple source and forwarding ports

•config traffic_segmentation [<portlist> <ch1-32>] forward_list [<portlist> <ch1-32>]

5Modify Spanning Tree command to support configuring recovery timer for ports which are shut down by loop

•config stp {maxage <value 6-40> maxhops <value 1-20>

hellotime <value 1-10> forwarddelay <value 4-30> fbpdu [enable disable] lbd [enable disable] lbd_recover_timer [<value 30-86400>]}

6Modify Port Security command to support lock_address_mode’s new parameters

• [<portlist> all] {admin_state [enable disable] max_learning_addr <int 1-64> lock_address_mode [Permanent DeleteOnTimeout DeleteOnReset] trap <interval 1-1000000>}

1 Change the command “config guest vlan” to “create 802.1x guest_vlan”

2Change the command “config guest_vlan ports” to “config 802.1x guest_vlan ports”

3Change the command “show guest_vlan” to “show 802.1x

guest_vlan”

4Change the command “config rate_limit” to “config bandwidth_control”

5Change the command “show rate_limit” to “show bandwidth_control”

6Modify “config snmp system_contact” command’s parameter

• Describe the allowable character number: <sw_location 0-31>

7Modify “config snmp system_name” command’s parameter

• Describe the allowable character number: <sw_name 0-31>

8Change the command “show cpu utilization” to “show utilization” and also add one more parameter

•Support two parameters: [ports cpu]

9Modify the parameter for “traceroute” command.

• change the packet size from “[size 40-1500]” to “[size 40-1472]”