2. # SW n1 n2 n3 n4 n5 n6 - Audio Switch Input

SWITCHERS

2.[# SW n1 n2 n3 n4 n5 n6] - Audio Switch Input

#= Switch number (no. from 1 to 9; default is 0).

n1 = Audio input number (no. from 0 to 6).

n2 = Break Away code: (0 = On; 1 = OFF)

n3 = 1, audio key pressed

n4 = 0, Sync Delay. The MX2436RM Switcher is equal to zero. It is not necessary for the switch to delay.

n5 = Video Equalizer (Hexadecimal no. from 1 to F).

n6 = Audio Gain (Hexadecimal no. from 1 to F).

This is the main command of the audio input switcher containing all the information needed by the switcher to activate the audio sources connected to the unit.

Example:

Sending the [8SW6012F8] command will activate switcher module 8 and audio input number 6 only (because the breakaway code is 0). The “1” will let the switcher know that the audio key was pressed with and interval of 2 (1 second), video equalizer was set to a maximum and a normal volume of 8. Zero (0) = OFF and default is 8 for normal volume or video).

3.[#RF] - Factory Reset

#= Switch number (default is 0)

This command will replace all the previously stored settings in the memory of the switcher module, which is indicated by the factory default setting. Note that previously stored settings will be lost.

Example:

Sending the [8RF] command resets the Switcher module with ID number eight to the factory settings.

4.[#RO] - Operation Reset

#= Switch number (default is 0)

This command will reset the following:

∙Audio and Video is set to input #1

∙Auto Switch is set to the OFF position

∙Beep is set to the ON position

The following will not be affected:

∙Audio Volume

∙Video Equalization

∙Auto Rotate

∙Sync Delay

Example:

Sending the [8RO] command resets the Switcher module with ID number eight to the Reset Mode.

5.[# SA n] - Audio Breakaway

#= Switch number (default is 0)

n = 1 (ON) Audio Breakaway, Audio Input Video Input and switchers can be activated separately.

n = 0 (OFF) In this mode the switchers are activated simultaneously. For example, if Video Input 2 is pressed, Audio Input 2 will be automatically activated.

This command controls audio and video input numbers that will be sent simultaneously or separately allowing the control of Audio input and the video input independently.

Example:

Sending the command [1SA1] will allow the user to select independently Audio Input from Video Input.

Sync Delay

The MX2436RM Switcher is equal to zero. Therefore, it is not necessary for the switch to delay.