SWITCHERS
INSTALLING YOUR MX2436RM | 6 |
Step 1. Make sure that the power input is set to the proper AC voltage for the country of usage. An incorrect setting may result in unit damage not covered by warranty.
Step 2. Connect the power cord to the unit and plug it into the power outlet.
Step 3. Connect the cables from the video sources and the audio sources (computers, VCR, etc.) to the input channels and connect the display devices (monitor or projector) and the appropriate audio equipment (mixer, amplifier, etc.) to the outputs. For better results use shielded, high quality coaxial cables.
Step 4. Test all the required switching features. If you experience difficulties or abnormal switching, you may wish to reset the unit to factory defaults to make sure that you have not entered an incorrect operation mode. To reset the switcher, turn OFF power and then turn power ON again while pressing and holding the “RESET” button. After a brief delay, all LED’s should blink ON and OFF. A beeping sound will be heard several times indicating that the switcher has been set to the factory preset position.
Step 5. Verify that the display and audio equipment operates properly and results in perfect images and sound.
For additional assistance, please refer to the FAQ Section or the Troubleshooting Guide.
OPERATION | 7 |
7.1 CONTROL PANEL
1.When any of the buttons are pressed and released a beeper will sound once. If a button is pressed and held a beeper will sound several times.
2.Default video and audio inputs are selected simultaneously by pressing and releasing one of the video input buttons. LED’s, which represent selected inputs on the control panel should turn “ON” The LED’s that represent selected video and audio inputs on the connector board should also turn “ON”.
3.When selecting audio inputs and video inputs separately, press the “AUDIO BREAK AWAY” mode button. If at any time, you need to return the MX2436RM Switcher to the previous mode position, press the “AUDIO BREAK AWAY” mode button.
4.Before setting the “VIDEO EQ” mode, you must determine the length of cable that is connected to each of the video inputs. To select the appropriate equalization, follow step
a)Select Video Input
b)Press and release the “VIDEO EQ” UP button as many times as needed to turn the video equalizer to the correct position. Each time this button is pressed, it equalizes for the next 25 ft of cable. (For equalization of 100ft of cable, press the button four times; for cable 150ft, press button six times; and for cable 375ft, press the button fifteen times and so on.)
c)To set the selected equalization to memory, press and hold the “VIDEO EQ” “Up” and “Down” buttons simultaneously for 2 seconds.
d)Repeat step b and c for equalization of any video input.
5.To set the “AUTO ROTATE” mode, use the “AUTO ROTATE” Up and Down buttons for selecting the appropriate rotation time. Video inputs begin to rotate as they connect to the
7