Allied Telesis AT-8000S Switch
Switch Installation Guide
Figure 18: Installing Rubber Feet
2.Set device down on a flat surface, while leaving 2 inches on each side and 5 inches at the back.
3.Ensure that the device has proper ventilation by allowing adequate space for ventilation between the device and the objects around the device.
Rack Installation
The device can be mounted in an EIA
Notes
•Disconnect all cables from the unit before mounting the device in a rack or cabinet.
•When mounting multiple devices into a rack, mount the devices from the bottom up. To install the device in a rack, perform the following:
1.It is recommended to put on an ESD wrist strap and attach the ESD clip to a metal surface to act as ground. An ESD strap is not supplied with the device.
2.Place the device on a flat and stable surface.
3.Place the supplied
Page 26