Allied Telesis AT-S87 manual Resolved Issues, Operational Notes

AT-S87 Version 1.0.0 Software Release Notes

ˆClass of Service

ˆSTP and RSTP

ˆPort Security

ˆStatistics

Resolved Issues

ˆThe IP access list in SSM edit window now displays more than 11 entries.

ˆWhen IGMP snooping, RSTP/STP and port trunking features are enabled, the three features are now compatible and behave as expected.

ˆWhen the name included a space for either a trunk member or a VLAN member, the parameters on the respective feature were affected abnormally. This bug has been resolved.

ˆThe system is now stable and will not enter into a loop condition if the user switches the mode between STP and RSTP.

ˆThe RMON counters now display the correct values.

ˆDuring a firmware upgrade, the AT-GS950/48 Gigabit Ethernet Smart Switch will not accept a file intended for the FS750/48 or FS750/24POE.

ˆBPDU packets will now flood all ports when STP/RSTP feature is disabled.

ˆThe system VLAN configuration has been moved from the page, “IP Setup”, to the page, “Tagged VLAN”.

ˆThe performance of TCP traffic has been improved compared to the previous version of code. Large file transfers will now complete in the time that is appropriate for the networking activity.

Operational Notes

ˆWhen a 100FX SFP is inserted into the AT-GS950/48 Gigabit Ethernet Smart Switch it will not be auto-detected and thus will initially not be operational. In order to make the SFP module active, you must manually configure each individual SFP port as follows where the 100FX SFP is used:

1.From the main menu on the left hand side of the web management page, select Physical Interface and the Physical Interface page is displayed

2.In the Port List, select one of the SFP ports (45 - 48) that you want to configure. The port is highlighted in the port list.

3.In the Mode list, select “100FX-Full” for the port speed and duplex mode:

4.Click Modify. The Admin mode setting shown in the table for that port is changed. How- ever, the SFP module configuration will not be activated and will not pass ethernet traffic until the port configuration change is committed to the display and it is permanently saved. See steps 6 and 7 below.

5.If you want to start the port re-configuration over, click Reload to clear the setting and go back to step 2.

6.Click the OK button to commit the port configuration change to the display. Although it may appear that the change is immediately activated, the change must first be perma- nently saved before this occurs - see in step 7 below.

7.To permanently save these settings in the configuration file and activate the change, select Save Configuration from the main menu on the left hand side of the web manage- ment page and then click the Save button.

PN 613-000911 Rev B 2 Allied Telesis, Inc.