Allied Telesis 2.6.1 manual Resource Reservation Protocol Rsvp, Layer 105

Layer 3 105

Figure 25: Example output from the SHOW APPLE PORT command.

Appletalk	Port	Details
------------------------------------
Port Number		..............	1
Interface			vlan11
ifIndex	..................		1
Node ID	..................		217
Network	Number		22
Network	Range Start		22
Network	Range End		22
State			ACTIVE
Seed			NO
Seed Network		Start	0
Seed Network		End	0
Hint			YES
Hint Node ID		.............	179
Hint Network		.............	22
Default	Zone	.............	-
Zone List is		Empty
------------------------------------

Resource Reservation Protocol (RSVP)

The Resource Reservation Protocol (RSVP) enables the receiver of a traffic flow to make the resource reservations necessary to ensure that the receiver obtains the desired QoS for the traffic flow.

RSVP is disabled by default. To enable RSVP, use the command:

ENABLE RSVP

Each IP interface that is to receive and process RSVP messages and accept reservation requests must be enabled. To enable RSVP on the admin VLAN, use the command:

ENABLE RSVP INTERFACE=vlan11

To display information about the interfaces enabled for RSVP (Figure 26), use the command:

SHOW RSVP INTERFACE

Figure 26: Example output from the SHOW RSVP INTERFACE command.

RSVP Interfaces
Maximum	Reserved	No. Of
Interface Enabled Bandwidth(%)	Bandwidth(%)	Reservations Debug	Encap

------------------------------------------------------------------------------

Dynamic	No	75	0	0	None	RAW
vlan11	Yes	75	0	1	None	RAW
ppp0	Yes	75	0	0	None	RAW

------------------------------------------------------------------------------

Software Release 2.6.1 C613-02039-00 REV A