APC AP9630 installation manual Mph0459a

The Network Management Card is sensitive to static electricity. When handling the Network Management Card, touch only the end plate while using one or more of these electrostatic-discharge devices (ESDs): wrist straps, heel straps, toe straps, or conductive shoes.

1.If a cable is connected to the serial port at the UPS or chassis, stop the APC service that uses that serial connection, and disconnect the cable.

2.If you are installing a chassis, connect the chassis to the UPS serial port.

3.Use the same screws that hold the expansion slot cover in place to secure the Network Management Card in the chassis slot.

mph0459a

4.Connect a network interface cable to the 10/100Base-T network connector on the front panel of the Network Management Card.

5.If you are using the AC Adapter (AP9505), connect the adapter to the chassis. Then connect the adapter to an independent AC input so that the Network Management Card can continue to operate if the UPS is turned off or fails.

6.If you disconnected a cable in step 1, reconnect that cable to the serial port at the chassis, and restart the associated APC service.

7.See “Quick Configuration” on page 8.

Installation Manual 7