APC AP9630 installation manual Command line interface

Command line interface

After you log on at the command line interface, as described in “Local access to the command line interface” on page 11 or “Remote access to the command line interface” on page 12, you can manually configure network settings.

1.Contact your network administrator to obtain the IP address, subnet mask, and default gateway for the Network Management Card.

2.Use these three commands to configure network settings. (Text in italics indicates a variable.)

a.tcpip -iyourIPaddress

b.tcpip -syourSubnetMask

c.tcpip -gyourDefaultGateway

For each variable, type a numeric value that has the format xxx.xxx.xxx.xxx.

For example, to set a system IP address of 156.205.14.141, type the following command and press ENTER:

tcpip -i 156.205.14.141

3.Type exit. The Network Management Card restarts to apply the changes.

Installation Manual 13