ATEN Technology CS-1762, CS-1764 user manual Firmware Upgrade Mode, Restore Default Settings

4. Hotkey Operation

Firmware Upgrade Mode

To set the CS-1762 / CS-1764 to Firmware Upgrade Mode, do the following:

1.Invoke HSM (see page 17 for details).

2.Key in: upgrade

3.Press [Enter].

The front panel LEDs flash to indicate Firmware Upgrade Mode is in effect.

Note: To exit Firmware Upgrade Mode, you must power off the switch.

Restore Default Settings

To reset the CS-1762 / CS-1764 to its default hotkey settings, do the following:

1.Invoke HSM (see page 17 for details).

2.Press [R] [Enter].

All hotkey settings return to the factory default settings. See “Hotkey Default Settings” on page 33.

21