Chapter 4 | Advanced Configuration |
Port > LACP Settings
Port Displays the port number. Enable LACP Enables LACP.
Admin Key A channel will only be formed between ports having the same admin key. This only applies to ports located on the same switch. The default setting is auto.
Click Save Settings to save any changes.
Port > LACP Status
From the LACP Status screen, you will see the LACP Status for each port, and its partner port number, and operational port key.
Port > LACP Status
LACP Port Status LACP Status on each interface since the device was last refreshed.
Protocol Active Indicates if the LACP is disabled or enabled on the interface.
Partner Port Number Indicates the port that is in the same LAG group.
Operational Port Key A channel will only be formed between ports having the same operational port key. This only applies to ports located on the same switch.
VLAN > VLAN Settings
A VLAN is a group of ports that can be located anywhere in the network, but communicate as though they belong to the same physical segment. VLANs help to simplify network management by allowing you to move devices to a new VLAN without having to change any physical connections. VLANs can be easily organized to reflect departmental groups (such as Marketing or R&D), usage groups (such as
To create a single VLAN, enter the VLAN ID, and click Add. Use the VLAN ID screen to configure port members or LAG members for a specific VLAN index.
VLAN > VLAN Settings
VLAN ID ID of configured VLAN
To remove a VLAN, select the VLANs in the VLAN list, then click Delete.
Click Save Settings to save any changes.
VLAN > VLAN Port Settings
You can configure VLAN behavior for specific interfaces, including the mode, accepted frame type, VLAN identifier (PVID), and ingress filtering.
VLAN > VLAN Port Settings