Linksys SLM2008, SLM2005 manual FCC Statement, Safety Notices, Industry Canada Statement

Page 27

Appendix C

Warranty and Regulatory Information

FCC Statement

This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which is found by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment or devices

Connect the equipment to an outlet other than the receiver’s

Consult a dealer or an experienced radio/TV technician for assistance

Safety Notices

Caution: To reduce the risk of fire, use only No.26 AWG or larger telecommunication line cord.

Do not use this product near water, for example, in a wet basement or near a swimming pool.

Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.

WARNING: This product contains lead, known to the State of California to cause cancer, and birth defects or other reproductive harm. Wash hands after handling.

Industry Canada Statement

This device complies with Industry Canada ICES-003 rule. Operation is subject to the following two conditions:

1.This device may not cause interference and

2.This device must accept any interference, including interference that may cause undesired operation of the device.

Règlement d’Industry Canada

Cet appareil est conforme à la norme NMB003 d’Industrie Canada.

Le fonctionnement est soumis aux conditions suivantes :

1.Ce périphérique ne doit pas causer d’interférences;

2.Ce périphérique doit accepter toutes les interférences reçues, y compris celles qui risquent d’entraîner un fonctionnement indésirable.

5-Port and 8-Port 10/100/1000 Gigabit Smart Switches with PD and AC Power

23

Image 27
Contents User Guide Online Resources About This GuideAbout This Guide Icon DescriptionsTable of Contents Appendix D Contact Information Appendix a Glossary Appendix B SpecificationsChapter Introduction ChapterBack Panel Chapter Product OverviewProduct Overview Front PanelOverview Chapter InstallationInstallation Pre-Installation ConsiderationsDesktop Placement Placement OptionsHardware Installation Wall-Mount PlacementSystem System Settings Chapter Advanced ConfigurationAdvanced Configuration SetupPort Port Settings Port Lacp SettingsPort Static Link Aggregation Vlan Vlan Settings Vlan Vlan Port SettingsPort Lacp Status Security 802.1X Settings Security Management Access List Security 802.1X ParameterSecurity Static MAC Address Queue Mode  QoS QoS SettingsSecurity Storm Control Rate ThresholdQoS Mode STP STP SettingsSTP Vlan Bridge Overview STP Port Settings STP STP Status Statistics Statistics OverviewMulticast Igmp Settings Admin PingStatistics Igmp Status Admin Save Configuration Admin Port MirrorAdmin Factory Default Admin RebootAdmin Firmware Upgrade Appendix a Appendix a GlossaryGlossary Glossary Smtp Simple Mail Transfer Protocol The standard e Appendix a SLM2005 Appendix B Specifications Specifications Appendix B10BASE‑T/100BASE-TX SLM2008Appendix C Warranty and Regulatory Information Limited WarrantyAppendix C Règlement d’Industry Canada Safety NoticesFCC Statement Industry Canada StatementDansk Danish Miljøinformation for kunder i EU Appendix C Norsk Norwegian Miljøinformasjon for kunder i EU Appendix C Contact Information Appendix D
Related manuals
Manual 3 pages 43.25 Kb