Linksys SLM2008, SLM2005 manual Chapter Installation, Overview, Pre-Installation Considerations

Page 7

Chapter 3

Chapter 3:

Installation

Overview

This chapter will explain how to connect network devices to the Switch. The following diagram shows a typical network configuration.

 

Cable/DSL

 

Wireless Access

Internet

Modem

Router

Point

Powered by Desktop

Notebook

Server

Switch

Typical Network Configuration

When you connect your network devices, make sure you don’t exceed the maximum cabling distance of 100 meters (328 feet).

Installation

Pre-Installation Considerations

Full-Duplex Considerations

The Switch provides full-duplex support for its RJ-45 ports. Full-duplex operation allows data to be sent and received simultaneously, doubling a port’s potential data throughput. If you will be using the Switch in full-duplex mode, the maximum cable length using Category 5 cable is 328 feet (100 meters).

1000BASE-T Cable Requirements

All Category 5 UTP cables that are used for 100BASE-TX connections should also work for 1000BASE-T, providing that all four wire pairs are connected. However, it is recommended that for all critical connections, or any new cable installations, Category 5e (enhanced Category

5)or Category 6 cable should be used. The Category

5e specification includes test parameters that are only recommendations for Category 5. Therefore, the first step in preparing existing Category 5 cabling for running 1000BASE-T is a simple test of the cable installation to be sure that it complies with the IEEE 802.3ab standards.

Positioning the Switch

Before you choose a location for the Switch, observe the following guidelines:

•Make sure that the Switch is accessible and that the cables can be connected easily.

•Keep cabling away from sources of electrical noise, power lines, and fluorescent lighting fixtures.

•Position the Switch away from water and moisture sources.

•To ensure adequate air flow around the Switch, be sure to provide a minimum clearance of two inches (50mm).

•Do not stack free-standing Switches more than four units high.

5-Port and 8-Port 10/100/1000 Gigabit Smart Switches with PD and AC Power



Page 6 Page 8
Image 7
Page 6 Page 8
Contents User Guide Online Resources About This GuideAbout This Guide Icon DescriptionsTable of Contents Appendix D Contact Information Appendix a Glossary Appendix B SpecificationsChapter Introduction ChapterBack Panel Chapter Product OverviewProduct Overview Front PanelOverview Chapter InstallationInstallation Pre-Installation ConsiderationsDesktop Placement Placement OptionsHardware Installation Wall-Mount PlacementSystem System Settings Chapter Advanced ConfigurationAdvanced Configuration SetupPort Lacp Settings Port Port SettingsPort Static Link Aggregation Vlan Vlan Port Settings Vlan Vlan SettingsPort Lacp Status Security 802.1X Settings Security 802.1X Parameter Security Management Access ListSecurity Static MAC Address Queue Mode  QoS QoS SettingsSecurity Storm Control Rate ThresholdQoS Mode STP STP SettingsSTP Vlan Bridge Overview STP Port Settings STP STP Status Statistics Statistics OverviewAdmin Ping Multicast Igmp SettingsStatistics Igmp Status Admin Save Configuration Admin Port MirrorAdmin Factory Default Admin RebootAdmin Firmware Upgrade Appendix a Glossary Appendix aGlossary Glossary Smtp Simple Mail Transfer Protocol The standard e Appendix a SLM2005 Appendix B SpecificationsSpecifications Appendix B10BASE‑T/100BASE-TX SLM2008Limited Warranty Appendix C Warranty and Regulatory InformationAppendix C Règlement d’Industry Canada Safety NoticesFCC Statement Industry Canada StatementDansk Danish Miljøinformation for kunder i EU Appendix C Norsk Norwegian Miljøinformasjon for kunder i EU Appendix C Contact Information Appendix D
Related manuals
Manual 3 pages 43.25 Kb
Top Page Image Contents