Advantech TPC-1260 manual Remove the CPU board

Page 55

Step 4: The CPU board is now visible. It connects to the I/O board by a 144-pin SO-DIMM connector and a 50-pin FPC connector.

Step 5: Use a pair of tweezers to loosen the 50-pin FPC connector, and release the FPC.

Step 6: Bend outward the two metal latches of the SO-DIMM connec tor by thumbs. The free end of the CPU board would swing up. Pull out the CPU board.

Figure 6.1-3 Remove the CPU board

Step 7: Insert a new CPU board to the SO-DIMM connector.

Step 8: Push down and lock the CPU board.

Step 9: Use a pair of tweezers to insert the 50-pin FPC to the connector on the CPU board. Then tighten the connector.

Step 10: Replace the CPU board cover and fasten the screw.

Warning: The CPU cover is used as the cooling media of the CPU. Thus it is usually of higher temperature than other parts of the system. Be careful not to touch this area without proper protection.

Chapter 1 General Information

4 7

Image 55

Contents TPC-1260 Copyright notice Acknowledgments Packing List FCC Class a Safety Instructions Wichtige Sicherheishinweise Contents Figures Tables Page General Information Introduction 2 I/O ports SpecificationsStorage Safety and environmentLCD Mtbf LCD specificationsPower Touchscreen specificationsI/O ports arrangement Panel mounting MountingWall mounting/desktop stand 1Exploded diagram Exploded diagram1 Dimensions and cutout Dimensions and cutoutSystem Quick Starting Unpack the package Install HDD Install CompactFlash memory card Plug the power lines to the system power receptor Turn on the system power switch Engine of the TPC-1260 Label Function CPC-2365 main boardConnector pin assingments 1 TPC-1260 I/O board I/O port side TPC-1260 I/O board2 TPC-1260 I/O board LCD side 1 TPC-1260 I/O board connector/jumper list Windows CE in the TPC-1260 1 Windows CE on TPC-1260 Soft-keyboard TPC-1260 utilitiesScreen saver 2 Screen saver setting Watchdog timerNetworking via Ethernet Networking2 Neworking by Windows Explorer 3 Remote networking Networking via serial port4 Make new connection 6 Default settings Web browser Application program developmentSystem requirements Building Windows CE runtime 1 Flow-chart of building Windows CE runtimePage System Tuning LCD brightness tuning LCD contrast tuning1 DOS/Windows Family Touchscreen calibrationWindows CE Double-click Windows Explorer 4 Calibration When calibration is done the utility will save the settings System Tune Up Page Maintenance 1 CPU board cover CPU board replacement3 Remove the CPU board 1 Replace the fuse Fuse replacementSerial Port Settings Baud Rate Settings SW1 Serial Port SettingsData Format/RS-422 Control Settings Page Watchdog Timer Programming Example Clear the watchdog timer Watchdog timer programming exampleWindows Touch Screen Installation Figure C-1 Hardware Touchscreen driver in WindowsClick the Device Manager… button Figure C-3 Uninstall the driver Figure C-4 Mouse properties Go to the Driver page, and click the Update Driver button Figure C-6 Select driver from known list Manufacturers list, find out and select Touch- Screen Figure C-8 Re-install the driver Figure C-9 Finish installation of touchscreen driver Fuse Specifications Fuse used on the TPC-1260 is Fuse Specifications