In the Configure Port dialog box, you can configure the Baud Rate, Data bits, Parity, Stop Bits and the flow control mode for that specific port (or for all ports). After you have configured all the settings you want to change, click OKto make this configuration active.
NOTE: When using All Ports Setup button or All Ports/
Setup 
menu command to configure settings for all ports, you must take care to stop any ports that are running test in order to configure them. If you do not stop the test running on a specific port, it won’t be configured at all. That is, you get to configure only the ports that have been stopped.
Run the Test
After you have completed the configuration of the port(s), you can now
start the test on the port you have selected by clicking the Run button or accessing the Port/Run menu command (or you want to run all ports at
once, just click the All Ports Run 
button or access All Ports/Run menu command).
Once the test is started, you can see relevant test information of port per- formance on the performance listing area.
Figure 4.5: Test Information on the Performance Listing Area
33 | Chapter4 |