Adder Technology X2 manual Video outputs, Remote module

SERIAL 1

2 Ensure that the other end of the twisted pair link connects to the corresponding numbered socket on the LOCAL module (labelled

TO REMOTE 1 to TO REMOTE 4).

Video outputs

You can connect multiple video monitors to the REMOTE module (up to two on the MS2 model or up to four on the MS4 model).

Twisted pair link connections

The links between the LOCAL and REMOTE modules are made using between one and four twisted pair cables, specified to Category 5 or higher.

1Attach the signal leads from each video monitor to the output sockets (labelled VIDEO OUT

1 to VIDEO OUT 4) on

the REMOTE module.

VIDEO	OUT
	4
VIDEO	OUT
	3
VIDEO	OUT
	2
VIDEO	OUT
	1

The various cable connections carry the following channel signals (if particular channels are not used, then corresponding link cables are not required):

Link cable	Channel signals carried
1	Keyboard, Mouse, Audio, Video 1, Serial 1
2	Video 2, Serial 2

3Video 3, Serial 3 (not MS2 model)

4Video 4, Serial 4 (not MS2 model)

IMPORTANT: Ensure that the total twisted pair cable length (including patch boxes) does not exceed 200 metres for any link cable. Ensure that the multiple link cables are all of the same length to avoid the risk of uneven delays on video images.

For each required link connection:

 

Connections from	REMOTE
monitors (two
outputs available
on MS2 model)

1Insert the connector from the twisted pair cable link into one of the sockets (labelled TO

TO

4

SERIAL

4

3

Serial cable connections You can attach multiple serial devices (such as touch screen inputs) to the remote module (up to two on the MS2 model or up to four on MS4 model).

Note: The links support software or hardware handshaking up to a maximum baud rate of 56Kb/s.

For each required serial connection:

1Connect the cable from the serial device to one of the

9 pin ports on the LOCAL

module (labelled to SERIAL 4).

2Ensure that the corresponding serial connection at the LOCAL module matches this device and the necessary port on the host system.

TO	LOCAL
		4
TO	LOCAL	SERIAL4
TO	LOCAL	SERIAL3
		2
		SERIAL
		2
TO		USEINDOOR
	LOCAL	ONLY
		1
		SERIAL
		1
		PO
		WER

REMOTE

Connections to serial devices (two outputs available on MS2 model)

LOCAL 1 to TO LOCAL 4).

	SERIAL
	3
	2
	SERIAL
	2
TO	USEINDOOR
	ONLY
	1
	SERIAL
	1
	PO
	WER

twisted pair

connections -

cables must beREMOTE of equal lengths

      

12