C o m m o n E r r o r s
Error Description/Action
002Name must be 1 to 8 characters inside quotes.
005Supply width is invalid.
018Code page selection defined in the field is invalid.
025Data length is too long.
101Format referenced by batch not in memory.
400Invalid character following {.
403Field separator was not found.
409Printer memory is full. Delete unnecessary formats or graphics from memory.
410Parity mismatch.
411Framing error (baud rate mismatch).
412Flow control mismatch.
413Online receive buffer is full. Check for a flow control problem.
611Font, bar code, or density in the batch does not fit the format.
612The data in this line of the batch is either missing or does not match the format.
613Reference point off supply.
614Portion of field off supply or there may be an invalid character in the packet.
703The printer sensed a calibration of
704Printer has not sensed a supply mark when expected or is out of supplies. Press Escape/Clear and try to continue printing. Change supply.
751Printer did not sense a black mark when expected. Press Escape/Clear and try to continue printing. Change supply.
752Printer sensed a mark in the wrong place.
753Printer sensed a mark that is too long.
754Check for a ribbon jam or remove any slack in the ribbon by turning the
755Printhead is open. Close the printhead.
756Load supplies.
757Load supplies (supply length mismatch). Press Feed/Cut.
758Either the supply is not seen, the
763Waiting to dispense label. Press Feed/Cut.
765The printhead has less than 8 bad dots and can shift bar code fields to avoid bad dots. Press Escape/Clear to continue printing.
768Printhead has more than 30 bad dots or is not connected. Connect the printhead.
11