Paxar Monarch 9825 manual Loading Labels for the Optional Peel Mode

Page 5

9.Hold the printhead assembly by the printhead tab while pressing down on the printhead release.

10.Close the printhead by pressing down on the thumb well until you hear it click into place.

11.Close the cover.

12.Press Feed/Cut to position the supply under the printhead.

Loading Labels for the Optional Peel Mode

Peel mode must be purchased separately. In peel mode, the printer separates the backing paper from the label. The next label is not printed until the completed one is removed from the printer. Make sure the printer is configured for on-demand mode and the correct supply type. The minimum feed length is 1.5 inches for peel mode. Hold the leading edge of peeled labels when printing on stock longer than six inches. You must use non-perforated supplies for peel mode. Follow the steps for loading supplies from the previous section. Then, follow these steps after you close the printhead.

1.Remove the labels from the first 10 inches of the backing paper.

2.Press down on the exit cover tabs to open the exit cover on the front of the printer.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Monarch 9825 Printer I n g t h e C o n t r o l P a n e l N n e c t i n g t h e C a b l e sA d i n g L a b e l s o r T a g s Supply Holder Guides Loading Labels for the Optional Peel Mode J u s t i n g t h e W i d e / N a r r o w K n o b s A d i n g R i b b o n Tab until the assembly locks into placeE a n i n g I n t i n gE a r i n g J a m s Platen Roller Problem Action TroubleshootingError Description/Action M m o n Error sCanadian D.O.C. Warning
Top Page Image Contents