Paxar 9445 manual Close the front panel

Page 27

2. Loading Supply

Die cut supply requires no sensor adjustment.

1.Do one of the following:

For black mark supply, turn the sensor adjustment knob counterclockwise until it stops. Do not force the knob.

For feed apertures, turn the sensor adjustment knob counterclockwise until it stops. Then turn the knob clockwise as determined below.

•Measure from the edge of the supply to the center of the aperture.

•Subtract 1/8 inch (3.1 mm) from the measurement.

•Multiply the result by 36 (if you are measuring in milli- meters, multiply by 1.41).

For example, if the measurement to the aperture center is 3/8 inch (9.5 mm), turn the knob 9 turns to center the sensor.

Loading Supplies

Sensor

Adjustment

Knob

2.Close the front panel.

2-19

Image 27

Contents Equipment Manual Canadian D.O.C. Warning User’s Manual PrefaceEquipment Manual Table of Contents Appendix C. Specifications Printer Supplies Installing the Printer Socket Power Cord RS-232 Cable Loading Supply Non-Peel ModePrinthead Lower Supply Lock Lever Guide Supply Core Shaft Outer Supply Holder Supply Shaft Printable Side Inside Inner Holder Supply Holder Lock Equipment Manual Turn the printhead lever to the right to lock the printhead Peel Mode Paper Take-up Backing Lock Outer Supply Spool Holder Place the new supply roll on the supply shaft as shown Supply Holder Lock Insert the backing paper under the clamp Labels Backing Paper Turn the printhead lever to the right to lock the printhead Loading Supplies Loading Fan-Fold Supply Labels Adjusting the Supply Sensor Close the front panel Adjusting the On Demand Sensor Loading a Ribbon Loading a Ribbon Roll Spool Holders Thermal Supply Indicator Ribbon Leader Feed Mark Rollers Ribbon Roll Loading a Ribbon Roll Loading a Ribbon Cassette Loading a Ribbon Roll Upper Ribbon Spool Guide Post Printhead Lever Adjusting the Display Equipment Manual Cleaning the Printhead and Platen Roller Printhead Platen Roller Appendix A. Converting Keyboard for Table Top Use Equipment Manual Head Test Failure Message Appendix B. TroubleshootingStart-Up and Printing Problem ActionAppendix B. Troubleshooting Cutting Problem ExplanationPrinter Appendix C. SpecificationsPrint Speed Without ribbon SuppliesPage U.S.A Canada