Paxar 9445 manual Spool Holders Thermal Supply Indicator

Page 31

3. Loading a Ribbon

4.Pull the ribbon spool holders off. Remove the old ribbon (if there is one).

5.Be sure the thermal supply indicator is pointing upward.

NOTE: Turn the thermal supply indicator to the right only if you are going to use thermal direct supplies (no ribbon).

Spool

Holders

Thermal

Supply

Indicator

6.Load a new ribbon onto the lower spool shaft so the ribbon unwinds clockwise.

3-3

Loading a Ribbon Roll

Image 31

Contents Equipment Manual Canadian D.O.C. Warning User’s Manual PrefaceEquipment Manual Table of Contents Appendix C. Specifications Printer Supplies Installing the Printer Socket Power Cord RS-232 Cable Loading Supply Non-Peel ModePrinthead Lower Supply Lock Lever Guide Supply Core Shaft Outer Supply Holder Supply Shaft Printable Side Inside Inner Holder Supply Holder Lock Equipment Manual Turn the printhead lever to the right to lock the printhead Peel Mode Paper Take-up Backing Lock Outer Supply Spool Holder Place the new supply roll on the supply shaft as shown Supply Holder Lock Insert the backing paper under the clamp Labels Backing Paper Turn the printhead lever to the right to lock the printhead Loading Supplies Loading Fan-Fold Supply Labels Adjusting the Supply Sensor Close the front panel Adjusting the On Demand Sensor Loading a Ribbon Loading a Ribbon Roll Spool Holders Thermal Supply Indicator Ribbon Leader Feed Mark Rollers Ribbon Roll Loading a Ribbon Roll Loading a Ribbon Cassette Loading a Ribbon Roll Upper Ribbon Spool Guide Post Printhead Lever Adjusting the Display Equipment Manual Cleaning the Printhead and Platen Roller Printhead Platen Roller Appendix A. Converting Keyboard for Table Top Use Equipment Manual Head Test Failure Message Appendix B. TroubleshootingStart-Up and Printing Problem ActionAppendix B. Troubleshooting Cutting Problem ExplanationPrinter Appendix C. SpecificationsPrint Speed Without ribbon SuppliesPage U.S.A Canada