Paxar 9445 manual Loading Supply, Non-Peel Mode

Page 9

2. Loading Supply

The printer prints both tags and labels. The supply may be wound with the printable side on either the inside or the outside.

This chapter explains how to load supply for

•Non-Peel Mode Printing (labels are printed in one strip. This can be used with Continuous Printing.)

•Peel Mode Printing (one label at a time while the backing paper rewinds inside the printer. This must be used with On Demand Printing.)

•Fan-Fold Mode Printing (fan-fold supply is printed in one strip). Call Service if you would like to use fan-fold supply.

NOTE: If your printer has a knife, follow the instructions under "Non-Peel Mode." You cannot use On Demand printing with a knife. Also, if your printer has a knife, it does not have the take-up spool shown in the instructions for loading supply.

If you are going to use thermal direct supply (no ribbon) and your printer is equipped with a ribbon roll adapter, turn the thermal supply indicator to the right. (See "Loading a Ribbon Roll" in Chapter 3.)

Non-Peel Mode

This mode is for both tags and labels. The printer dispenses the desired amount of supply without separating the backing paper from the label. This mode is usually used with continuous printing.

1.Open the front panel.

Loading Supplies

2-1

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Equipment Manual Canadian D.O.C. Warning User’s Manual PrefaceEquipment Manual Table of Contents Appendix C. Specifications Printer Supplies Installing the Printer Socket Power Cord RS-232 Cable Loading Supply Non-Peel ModePrinthead Lower Supply Lock Lever Guide Supply Core Shaft Outer Supply Holder Supply Shaft Printable Side Inside Inner Holder Supply Holder Lock Equipment Manual Turn the printhead lever to the right to lock the printhead Peel Mode Paper Take-up Backing Lock Outer Supply Spool Holder Place the new supply roll on the supply shaft as shown Supply Holder Lock Insert the backing paper under the clamp Labels Backing Paper Turn the printhead lever to the right to lock the printhead Loading Supplies Loading Fan-Fold Supply Labels Adjusting the Supply Sensor Close the front panel Adjusting the On Demand Sensor Loading a Ribbon Loading a Ribbon Roll Spool Holders Thermal Supply Indicator Ribbon Leader Feed Mark Rollers Ribbon Roll Loading a Ribbon Roll Loading a Ribbon Cassette Loading a Ribbon Roll Upper Ribbon Spool Guide Post Printhead Lever Adjusting the Display Equipment Manual Cleaning the Printhead and Platen Roller Printhead Platen Roller Appendix A. Converting Keyboard for Table Top Use Equipment Manual Head Test Failure Message Appendix B. TroubleshootingStart-Up and Printing Problem ActionAppendix B. Troubleshooting Cutting Problem ExplanationPrinter Appendix C. SpecificationsPrint Speed Without ribbon SuppliesPage U.S.A Canada
Top Page Image Contents