Using the 3Com Local Power Supply
To connect the local power supply to the IntelliJack, follow these steps (as shown in the previous diagram):
1Route the power cable through the strain relief on the top of the IntelliJack.
2Plug the power cable into the IntelliJack.
3Check to ensure that the cable is secure in the strain relief.
4Route the cable behind the trim ring from top to bottom.
5Secure the local power supply and cable to the wall.
6Plug the local power supply into the power source.
WARNING: Only use the local power supply available from 3Com. Failure to do so may result in damage to the IntelliJack, or may result in a hazardous situation.
71