Powering On The PathBuilder S21x Switch
Powering On The PathBuilder S21x Switch
Introduction | This section describes the sequence of events when you power up the PathBuilder |
| S21x switch. |
Powering On the The PathBuilder S21x switch does not have a power switch on the unit. Follow these
PathBuilder S21x steps to power on the PathBuilder S21x switch:
Switch
Step
Action
1Plug the DC output cable of the power supply into the power socket on the PathBuilder S21x switch back panel.
2Connect the power cord to the power supply outlet.
Warning
When powering down the unit, you should always unplug the power cord at the power supply outlet. Do not remove the power cord from the back of the unit.
Avertissement
Lors de l’arrêt de l’unité, débrancheztoujours le cordon d’alimentation du bloc d’alimentation. Ne le débranchez pas de l’arrière de l’unité.
Warnung
Nach dem Abschalten des Gerätes sollten Sie immer den Netzstecker des Gerätes aus der Steckdose ziehen. Entfernen Sie nicht das Netzkabel von der Geräterückseite.
Warning
Hazardous voltage from the telecommunications network may be accessible on un- earthed units. Disconnect all telecommunications cables before removing the main lead from the power supply.
Avertissement
Des tensions dangereuses provenant des réseaux de télécommunication peuvent être présentes sur des unités qui ne sont pas reliées à la terre. Déconnectez tous les câbles de télécommunication avant de retirer le câble de secteur du bloc d’alimentation.
Warnung
An nicht geerdeten Geräten können gefährliche Spannungen vom Telekommunikationsnetz anliegen. Trennen Sie alle Kabelverbindungen zum Telekommunikationsnetz, bevor Sie das Hauptnetzkabel aus der Steckdose ziehen.
Powering on the PathBuilder S21x Switch |