While Setting Up Your Configuration
While Setting Up Your Configuration
Introduction | This section describes the ways you can use to isolate problems that you may | ||||||||||
| encounter while setting up a PathBuilder S21x switch to pass IP traffic over PPP | ||||||||||
| links. For discussion purposes, the following network configuration (shown in | ||||||||||
| Figure |
|
|
|
|
|
|
| |||
|
| Note |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
| |
|
| The configuration of the local PathBuilder S21x switch and the number to call | |||||||||
|
| can be obtained by defaulting the | |||||||||
|
| CTP’s Main menu. |
|
|
|
|
|
|
| ||
|
|
| 10.10.10.1 | 10.10.20.1 | 10.10.20.2 |
|
| ||||
| 10.10.10.0 |
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
| 10.10.30.0 | ||
| Your Local |
|
|
|
|
|
|
|
| ||
|
| Local |
| Network |
| Remote |
| Remote | |||
|
| Network |
| PB S200 |
|
| PB S200 |
| |||
|
|
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
| Network |
|
|
| (905) |
|
| (905) | |||||
|
|
|
|
|
| ||||||
| Figure |
| |||||||||
|
| Note |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
| |
|
| The IP addresses used in this configuration example are for illustration purposes | |||||||||
|
| only. You must obtain registered IP addresses from your network administrator | |||||||||
|
| or your Internet Service provider, and configure them in your PathBuilder S21x | |||||||||
|
| switch before connecting to the Internet or Intranet. | |||||||||
Checking the |
|
|
|
|
|
|
| ||||
Use these procedures to check your PathBuilder S200 series switch connection and | |||||||||||
Physical | interface: |
|
|
|
|
|
|
|
|
| |
Connection |
|
|
|
|
|
|
|
|
|
|
|
Step
Action
1Ensure that the STS LED is ON to confirm that power is connected and that the unit is working. (Other LEDs may be ON or blink occasionally.)
2If the STS LED flashes continuously for more than 30 seconds after the power is applied, the software image in the flash is corrupted and the node is waiting for software to be coldloaded. Refer to the Software Installation and Coldloading Manual for more infromation on cold- loading software.
3If you are connected to the control port using an async terminal, (9600 bps, 8 bits, no parity), type “AT <CR>” and confirm that the Path- Builder S200 series switch outputs “OK.” Then log into the CTP.
Troubleshooting Your PathBuilder S21x Switch |