3Com 5108M-TP manual Dip Switch SW1 Port Status

Configure the switches to the settings you want if different than the default values. (Refer to Table 1-2, Table 1-3, Table 1-4, and Table 1-5 for an explanation of the dip switch settings.) Figure 1-2 shows the location of the dip switches.

Figure 1-2. 10BASE-T Module and Dip Switch Locations

Dip Switch SW1 (Port Status)

The eight switches on dip switch SW1 allow you to enable or disable each of the eight ports. The switches are labeled 1 through 8 and correspond to the respective eight ports. The Off position disables the port and the On position enables the port. The switch settings are initially configured in the

Introduction 1 - 5