System Requirements Macintosh
The following table lists the minimum and high volume recommended system setup to run RIP Software. System requirements vary according to the size of the files to be printed, the output device used, and other variables. Your particular setup and intended use of the software determine what hardware and software setup you need to get the most out of RIP Software. If you are working with relatively small files, the minimum setup may be sufficient. Similarly, if you are working with large files, you should consider the recommended setup. Consult your dealer for advice when choosing a system.
| Minimum | Recommended | |
|
|
| |
Processor | Power PC 166 | G3 or G4 300 MHz or faster | |
|
|
| |
RAM | 128 MB RAM with at least 196 MB of | 256 MB RAM with at least 257 MB of | |
virtual memory enabled | virtual memory enabled | ||
| |||
Install Space | 200MB | 200MB | |
|
|
| |
Working Disk | 2GB or more | 4GB or more for storage | |
Space | |||
|
| ||
Operating System | Mac OS 8.5 – 9x with Appearance | Mac OS 8.5 – 9.x with Appearance | |
Manager and ColorSync installed | Manager and ColorSync installed | ||
| |||
Video | 800 x 600 screen resolution with 16 bit | 1024 x 768 screen resolution with 16 bit | |
colors | colors | ||
| |||
Others | 4x | 16x | |
|
|
| |
Parallel Output | MAC/PCI Card | MAC/PCI Card | |
|
|
| |
USB Output | |||
|
|
| |
Network Output (*) | 10 | 100 | |
|
|
|
(*)Only when printers with network capabilities are used. TCP/IP should be installed and working properly.
6