Supplement
Printing and Cutting Limitations and Workarounds in Illustrator 9.0
Printing and cutting are subject to some limitations when you use the transparency feature in Illustrator 9.0. This section provides details about cases where limitations occur and describes workarounds.
Effects That Limit Cutting (The Illustrator 9.0 Transparency Feature)
The cutting line (CutContour) may be printed if there is even a single object on the Illustrator 9.0 artboard to which any of the following effects have been applied. This means that printing and cutting cannot be carried out at the same time as long as any of these effects are used.
•[Filter] > [Stylize] > [Drop Shadow]
•[Effect] > [Stylize] > [Blur]
•[Effect] > [Stylize] > [Drop Shadow]
•[Effect] > [Stylize] > [Inner Glow]
•[Effect] > [Stylize] > [Outer Glow]
•[Object] > [Rasterize] (only when Background is set to Transparent)
•When Mode is other than Normal at the Transparency palette (Window > Show Transparency).
•When Opacity is other than 100% at the Transparency palette (Window > Show Transparency).
•When Make Opacity Mask is executed at the Transparency palette (Window > Show Transparency).
When Background is set to Transparent by Effect > Rasterize > Raster Effects Setting, the cutting line may be printed when any of the following effects are used.
•[Effect] > [Blur]
•[Effect] > [Artistic]
•[Effect] > [Sharpen]
•[Effect] > [Sketch]
•[Effect] > [Texture]
•[Effect] > [Video]
•[Effect] > [Pixelate]
•[Effect] > [Brush Strokes]
•[Effect] > [Stylize]
•[Effect] > [Distort]
The cutting line is also printed if it is specified using Overprint Stroke or an object superimposed over the cutting line is specified using Overprint Stroke or Overprint Fill. However, you can avoid this by going to the Print dialog box and checking the check box for "Ignore Overprinting in Composite Output."
Workarounds for Limitations
One method for performing printing and cutting while still using the effects with these limitations is to carry out first only the printing without performing a form feed after printing, and then to carry out only the cutting at the same location.
1.In Illustrator 9.0, draw the cutting line in a different layer than the objects you want to print. You can create a new layer by going to the Window menu and using Show Layers to display the Layers palette.
2.Use the Layers palette to hide the layer where the cutting line is drawn.
3.In Roland ColorChoice, display Setup Properties. Select the Print tab, and then click the Driver Options button.
4.Uncheck the Advance After Plot check box.
5.Go to "Advanced Printing Procedures" as described earlier in this document and follow the procedures under "Illustrator 9.0" to make other settings.
6.Perform output with Illustrator 9.0. Carry out only printing, without performing cutting. After printing, return the page and do not update the origin point.
49