The hard drive jumper settings should be master or factory default.
Be careful not to damage any cables or components and double check the connection between the cables, the bridge board and your hard drive before you close up the case.
Hard Drive Assembly
Connect the ATA cable and the power line to your hard drive. Install the hard drive and fasten the screws. Align the top cover with the body and fasten the screws, before you slide it back into the casing. Fasten the 4 screws on the bottom and connect your power adapter and interface cable.
Copyright . 2004 by Rosewill Inc. - www.rosewill.com | - 5 - |