Rose electronic MultiStation manual Multistation PC Installation and Operations Manual

2.Select “BIOS Features Setup”, enter “VGA Boot from”, and select the option “AGP”

3.Select “Integrated Peripherals” and press enter. Select “Init Display First”, then select “Enabled”.

4.Select “PNP, PCI & ON-BOARD I/O” and then select the “Init Display First” option.

OPTION 2B – PCI video adapter

If your main computer uses a PCI video adapter and the video is only displaying on the remote user module’s monitor, power down your computer and remove the MultiStation PC’s PCI card and move your PCI video card to the slot that was occupied by the MultiStation PC’s PCI card. Do not install the MultiStation PC’s PCI card at this time. Re- boot your system and Windows XP will recognize the new hardware and install it. Re-install the MultiStation PC’s PCI card in the slot that was previously occupied by the PCI video adapter and reboot the system. The boot-up sequence should now appear on the video monitor connected to the PC and not on the monitor connected to the remove user module.

Installation of software causes conflicts with my resident programs

If you experience installation conflicts with startup or resident applications, it would be advisable to un-install the MultiStation PC software, reboot, then disable these applications, reboot, and reinstall the MultiStation PC Software. Once your reinstall the MultiStation PC software and reboot your PC, enable the startup or resident applications you disabled and reboot again.

NOTE:

Consult your Operating systems manual or vendor for instruction on disabling/enabling your startup and resident programs applications.

"Blue Screen" Page Fault Error Message Received after software install

When the installation is completed, you will be prompted to re-boot your system. If you receive a blue screen "Page Fault Error Message" during the re-boot process, please call Rose Electronics Tech Support. It may be determined that your system board is not compatible with the MultiStation PC software. This may be correctable with a firmware change.

20MULTISTATION PC INSTALLATION AND OPERATIONS MANUAL