Introduction
The installation assumes the following:
You have an active Ethernet TCP/IP network.
You are connecting the UltraLink to four standalone computers or a KVM switch.
You have a PC on the network where you will install the Viewer software.
Connections
UltraLink configuration
J
Connect the cables to the UltraLink.
The Quad UltraLink consists of four independent modules. Each one must be setup and configured.
Connect a keyboard, monitor, and mouse to the appropriate connectors on one of the modules.
Connect a network cable (not provided) to your 10MB or 100MB Ethernet network port.
(Note: The four network outputs can be connected to a hub)
Connect the DB25 connectors to a KVM switch or to four standalone computers with one of the provided cables. Use the DB25 to DB25 cable to connect to the KVM ports of a Rose KVM switch. Use the Db25 to
Note: These instructions apply for each of the 4 modules
Configure the UltraLink IP address
Power on the UltraLink and you will see its
Hit F10 to go to the UltraLink configuration. The screen changes color from green to gray.
Hit F1 if you want to read some help.
Enter a user ID of “admin” with no password.
Enter the IP address, subnet mask, optional gateway address, TCP port, and Speed/duplex for this UltraLink.
Hit F10 to save the network information.
This UltraLink is now active at this address.
Repeat the above procedure for each of the four UltraLink modules.