Start Up
About Logins
A default administrator account exists for initial configuration when the UltraLink first starts up. The user ID is admin and there is no password.
IMPORTANT One of the first steps an administrator should perform is to secure the user ID and password for the default administrator account. Change them with the UltraLink Viewer using the default account and the Security Settings dialog. If you forget the administrator user ID or password, override the user ID and password check as described in Password Defeat.
There are two types of logins:
•Connect login — connects the local KVM to the Switch/CPU device attached to the UltraLink
•Configure login — configures the IP address
Press the F9 key to display the connect login screen or the F10 key to display the configure login screen. Each screen is a different color. You must use the administrator user ID for the configure login.
You may press the F1 key to view help text on a login screen. Press F1 again to remove the help text from the screen.
Figure 6 The configure login screen
UltraLink User Manual |
| 9 |
|
|
|
|
|