INSTALLATION
Installation
Please refer to the safety section first before proceeding with any installation or configuration of the CrystalView Pro CAT5.
NOTE: If your CPU uses a DVI video card and the KVM station’s monitor is a TFT (flat panel) DVI monitor, pixelclock and phase adjustments should not be needed. Refer to the
When installing the CrystalView Pro CAT5, locate the transmitter as close as possible to the CPU or switch. Keep the CPU cables as short as possible but still give some freedom of movement. Using shorter VGA cables keeps the video noise to a minimum and reduces installation costs. You can mount the CrystalView Pro CAT5 in a CPU rack with the optional rack mount kit. When mounting the units in a rack, follow the instructions in Appendix D and Appendix E. Provide adequate air circulation to assure that the maximum operating temperature is not exceeded.
Wherever the transmitter and receiver units are located, they should be on a secure surface and free from obstructions and objects that may cause damage to the units.
| A | 1 | 2 |
| 3 |
|
|
|
| Transmitter | Receiver |
| |
| B | 1 | 2 | 3 | 4 |
|
|
|
| Switch | Transmitter Receiver | ||
C | 1 | 2 | 3 | 4 |
| 5 |
|
| Switch | Transmitter Receiver | Switch | ||
Figure 9. Typical cabling configurations
(See Figure 1, 2, or 3 for the connector locations for your model)
NOTE: Using a PC model with local access, a second KVM station can be connected to the transmitter.
Refer to Figure 11 for the
| 14 |
| CRYSTALVIEW PRO CAT5 INSTALLATION AND OPERATIONS MANUAL |
|
|
|
|